AQUA SPAS Spa Guide d'installation télécharger pdf (Page 5)

Aqua Spas – Gold TV Hot Tub Manual

Aqua Spas 5

Installation & Preparation

Hot Tub Base

Your hot tub needs a good solid foundation. The foundation on which your hot tub sits must be

able to support the weight of the tub, the water in it and the weight of its users. If the

foundation is inadequate, the tub may shift every now and again. This will cause stress to the

shell which may eventually lead to small cracks. Damage caused by an inadequate or improper

foundation is not usually covered by hot tub warranties. It is the responsibility of the hot tub

owner to provide a proper foundation for the hot tub.

A hot tub containing both water and people is extremely heavy. If you are installing the tub

onto wooden decking or an other elevated structure, it is advisable to consult a structural

engineer to ensure that the structure will support the weight of the tub.

Ideally, hot tubs should be installed onto a concrete base at least 4” thick.

If you are installing your hot tub indoors, ensure that your choice of flooring is impermeable to

water. Ensure that water drains away from the spa, protecting the cabinet and electrical

components from water damage.

Water Supply

Hot Tubs do not require a permanent water supply however there must be a non-softened water

supply and hosepipe within reach in order to fill the tub. A hosepipe is also used for emptying

the hot tub via the bottom drain or by using a submersible pump. An accessible drain in which

to direct the emptying water is useful.

Safety

Do not place your hot tub within 3 metres of overhead power lines. Make sure your hot tub is

positioned so that access to the equipment compartment and side panels will not be blocked.

On the Atlantic and sunset spas, the access panel is on the longest side.

Taking Delivery - Check the dimensions of

your hot tub and compare them to the width of

any gates and paths along the delivery route

between the road and the installation site. It

may be necessary for you to remove a gate or

partially remove a fence in order to provide an

unobstructed passageway.

If the delivery route will require a 90° turn,

don’t forget to check the measurements to

ensure the hot tub will fit through. Also, look

for any protruding utility meters, low roof

eaves, overhanging trees or gutters that might

cause an obstruction.

In some circumstances it might be necessary

to hire a crane for the installation. This could

be to avoid damage to the tub or to your

property, or simply because there is no other

way to get the tub into position.

1 2 3 4 5 6 7 8 9 10 ... 17 18

Commentaires sur ces manuels

Pas de commentaire

AQUA SPAS Spa Guide d'installation Page 5

Commentaires sur ces manuels